The process of operating a small flake ice machine
The user should check whether the water supply equipment is normal and whether the amount of water in the water tank is reasonable before operating the small ice sheet machine;If there is no problem, plug in the plug, the ice sheet machine starts to work, the water pump starts to run for about 2 minutes, the compressor starts to run and enters the ice making state.
When the borneol reaches the set thickness, the borneol probe starts, the defrosting electromagnetic cabinet begins to work, about 1 minutes after the borneol falls, when the ice falls, the ice fall gear turns over, the magnetic spring switch is opened, and the machine enters the ice state again with the reclosing of the magnetic spring switch.
When the bucket is full of ice, the magnetic reed switch can not automatically close, the machine will automatically stop working.After enough ice is taken out, the magnetic reed switch is turned off again. After a delay of 3 minutes, the machine starts and the ice making process is resumed.
Borneol placed place requirement is flat and level, away from heat source, without too much sun exposure, environmental ventilation, without sundry pile up around, condenser fan with metope to keep a distance of 1 meter at least, to ensure the machine good heat dissipation, otherwise will bring flake ice machine running a certain hidden trouble, or produce noise, influence the performance of the equipment and the production, please note that the site environment temperature cannot exceed 38 ℃, so as to avoid the environment temperatureToo high, resulting in poor condenser heat dissipation, affecting the ice - making effect.
The ice sheet machine should adopt the water source in line with the local drinking water standard, and install filters to remove impurities in the water, so as to avoid blocking the water pipe and affect the ice making effect.During the working process of borneol machine, if the equipment is found to stop without reason, it should be timely found out whether it is electrical cause, and then it can be re-run after troubleshooting.
After entering the precooling stop refrigeration, refrigeration, after about 30 minutes flake ice machine can turn it off, otherwise it will cause flake ice machine is frozen, or even damaged, have the effect of heat in the process of condenser in refrigeration, ice making direct impact on condenser cleaning effect, therefore, need to ensure the cleanliness, flake ice machine hose, sink, storeroom etc should be cleaned once every two months.
